CMT USA Downcut Spiral Bit, Solid Carbide, 1/8 in, 2 Flute, Downward Chip Ejection

Clean cuts with less fuss.

Solid carbide edge for a cleaner top surface.

Product Overview:

Downcut spiral bit work is where small details start to matter fast. This CMT USA cutter gives you a keen edge, a low angle spiral, and downward chip ejection, so the top side stays cleaner while the tool runs cooler. If you are chasing tidy edges in wood, this one feels like a good steady hand at the bench. It is built with super micrograin carbide and a premium HWM body, so the cut stays crisp when the job runs long. Picture a smoother finish, less ragged cleanup, and that quiet little bit of relief when the piece comes off the table looking right.

Key Features:

• Solid carbide cutting edge keeps the bite sharp, so you get a clean pass without babying the tool.
• Low angle spiral shears wood cleanly and helps chips move down and out instead of crowding the cut.
• Downward chip ejection leaves the upper surface tidier, which saves you some cleanup later on.
• Two flute design gives you a balanced cut that feels smooth and controlled, not twitchy or rough.
• Super micrograin carbide formulation helps the edge hold up longer, so the bit stays useful through more work.
• Premium HWM construction supports cooler running and a finer finish when you need the piece to look right.

Quick Specs:

• Brand: CMT USA
• Manufacturer: CMT USA
• Model Number: 192.001.11

Set this bit in place when you want a neater top edge and a calmer cut, without the extra grief. If that sounds like the kind of finish you want to hear and feel in your shop, shall we take the next step?